How to Download and Install Dtech Usb Serial Driver for Windows 10
If you have a Dtech USB to RS232/RS422/RS485 converter cable and want to use it on your Windows 10 computer, you need to download and install the Dtech Usb Serial Driver. This driver allows your computer to communicate with the USB converter cable and the serial device connected to it.
In this article, we will show you how to download and install the Dtech Usb Serial Driver for Windows 10 in a few simple steps.
Dtech Usb Serial Driver Download Windows 10 22
Step 1: Download the Dtech Usb Serial Driver
The first step is to download the Dtech Usb Serial Driver from the official website of Dtech Electronics. You can use the following link to access the download page:
On this page, you will see two files for the DT-5019 USB converter cable. One is for Windows 7/8/10 (32-bit) and the other is for Mac OS. You need to download the file that matches your operating system and system architecture.
For example, if you have a Windows 10 32-bit computer, you need to download the file named \"DT-5010/5011/5031/5051 WIN7,8,10 driver X32\". To download the file, click on the \"download\" button next to it.
The file size is about 2 MB and it will be saved as a ZIP file on your computer.
Step 2: Extract and Install the Dtech Usb Serial Driver
The next step is to extract and install the Dtech Usb Serial Driver from the ZIP file. To do this, follow these steps:
Locate the ZIP file on your computer and right-click on it. Select \"Extract All\" from the menu.
Choose a destination folder where you want to extract the files and click on \"Extract\".
Open the extracted folder and double-click on the file named \"Setup.exe\". This will launch the installation wizard.
Follow the on-screen instructions to complete the installation. You may need to accept the license agreement and choose a destination folder for the driver.
When the installation is finished, click on \"Finish\" to exit the wizard.
Step 3: Connect and Use Your USB Converter Cable
The final step is to connect and use your USB converter cable with your serial device. To do this, follow these steps:
Plug one end of your USB converter cable into an available USB port on your computer.
Plug the other end of your USB converter cable into your serial device. Make sure that you use the correct connector (RS232, RS422 or RS485) for your device.
Wait for a few seconds until Windows detects and installs your USB converter cable. You should see a notification that says \"Your device is ready\".
Open Device Manager on your computer and expand the \"Ports (COM & LPT)\" section. You should see a new COM port assigned to your USB converter cable. Note down this COM port number as you will need it later.
Open your serial communication software (such as PuTTY or HyperTerminal) and configure it to use the COM port number that you noted down. You can also adjust other settings such as baud rate, parity, data bits and stop bits according to your device's specifications.
Start communicating with your serial device using your USB converter cable.
Congratulations! You have successfully downloaded and installed the Dtech Usb Serial Driver for Windows 10 and used your USB converter cable with your serial device. 29c81ba772